0412-gas-mask
This is fashionable attire during the covid-19 pandemic. This respirator is used for boat work such as fiberglass work or painting were toxic fumes are given off. I also use it for sanding fiberglass as it makes a very effective dust mask. I have replacement filter cartridges but still on the original. This is better than N-95 masks but is a bit overkill and would look odd in the supermarket.

0412-minestrone
A bowl of minestrone for my recipe web pages.

0413-aloo-gobi
A bowl of slow cooker aloo gobi for my recipe web pages.

0413-white-bean-soup
A bowl of white bean soup for my recipe web pages.

0417-chickpea-potato
Ingredients before and after preparation and the ingredients in the slow cooker for indian-spice chickpea and potato. Again this is for my recipe web pages. Something to do during covid-19 stay at home.

0417-minestrone
Minestrone ingredients and the finished soup. In this case we were restricted in the ingredients and had to go with some brands we normally wouldn't use. It came out great anyway. Heavy on the kale since we had a lot to use up.

0417-saint-of-miracles
This was an odd placement of photos in the kitchen. Daniel's high school photo with his sax ended up under the caption "Saint of Miracles". Maybe he's really that good on the sax but not likely.

0421-gas-mask
Just more fooling around with the boat work mask.

0506-mast-sections
These photos were taken just to get an image of the mast sections.

0513-disinfecting
The garden sprayer was used as a prop to pretend we were disinfecting Daniel for a visit. We sent this to Erin and she wasn't sure if this was serious.

0526-battery-module
This was a slightly better set of photos of the 48V battery module prototype. This was to get a better look and before designing an improved final version.

0602-vberth-inards
This set of photos are the vberth area where the gray water tank will go, the existing chain locker washdown pump, and a tracing of the shower sump bilge pump hose. A 9 gallon gray water tank will fit. The terrible wiring job and rusty washdown pump is typical of previous owner installation. The tiny limber hole from the vberth to shower sump is where the bilge pump wire is run. The bilge pump hose does a 180 degree turn, passes through a hole into the main bilge area, then loops back through two more holes into the area under the vanity, then went out the through hull for the vanity sink. The pump itself will likely be replaced. Another part of this exercise was trying to figure out how to get a real shower sump of some sort in this space rather than draining the shower into a small bilge area.

0604-panels
These two photos were taken to help put together a drawing for the new breaker panel and then figure out details of the wire routing.

0627-tara-beach-walk
This is Tara's dog walk, sans dog. Erin is involved in a virtual walk fundraiser for a dog shelter and needs to get photos of people who have taken a mile walk. Its 0.6 mile home to beach and we took a longer way back so well over a mile. Some exercise and a good cause.